Getting back to old projects

Tool Shed Support Bracing

There are many little projects I have been skipping over and meaning to get to. One of them was to revisit the tool shed. 

The two rear support 4×4’s were not plumb. It looks like the building was shifting slowly down the hill… but looking back at old photos it might have just been the way I built it 🙂 So we jacked up the shed and added the bracing that I should have had in place from the start…

Last week we finally got around to finishing the trim off… about time… We also installed a solar light from Harbor Freight and cleaned the inside up a bit…

Leave a Reply

Your email address will not be published. Required fields are marked *